Not to be confused with my other Spiderbot scratchbuild, these little miniatures were just created in a moment of ‘I wonder if’. I do that quite often when I should be doing something else. Taking inspiration from the film Minority Report, I thought I could create a tiny spider like bot.
I started with some wire paper clips to act as the legs. I went with paper clips because the wire is very strong and would be able to support any size of body the robots ended up with.

I quickly decided to make the robots small enough to fit a few on a single base. Getting immediately distracted I made a suitable looking base for the miniatures out of sculpting putty, adding metal plates for that sci-fi look.

Each robot would have four legs so I made a very simple body shape out of the putty and drilled four tiny holes in the back to mount the legs in.

I then bent the each of the paper clip wire pieces at slightly different angles to eachother but all had a specific bend at one end to fit into the holes in the body.

A bit of trial and error and each robot had a good dynamic pose with the legs attached. I just used supeglue to stick the legs.

I tested the placement of all three robots on the base and then drilled holes for each robot leg touching the base. This would help keep the robots in place better than just gluing them direct to the base.

To show the scale here are the robots next to an old Ground Zero Games 25mm miniature.
All that was left to do was to paint them. I felt the only thing that would work would be to paint them metalic silver. I also decided at this point to make a small eye slot at the front of the robots. This was done simply by draging a file across the front of the putty body.

And there you have it a very simple but effective miniature for my Sci-Fi games.